Electricity and Magnetism

Simple electromagnet

Practical Activity for 14-16 PRACTICAL PHYISCS

Class practical

An introductory experiment showing that electromagnets can conveniently be switched on and off.

Apparatus and Materials

For each student group

Health & Safety and Technical Notes

Read our standard health & safety guidance

The nail should be made of iron which is magnetically soft (cut nails are suitable).

The nail may also have gained some magnetism while it has been lying in a cupboard in the Earth's magnetic field. This is easily remedied by heating the nail to cherry red heat and allowing it to cool in the East-West direction. Alternatively use a demagnetising coil, in which an alternating potential difference is connected to a solenoid, and the nail is then slowly withdrawn from the coil to a distance from it.


  1. Wind a few dozen turns of insulated wire around an iron nail. (Leave enough wire free at either end to make connections to the power supply.)
  2. Connect the ends of the wire to the low-voltage DC power supply, so that a large current flows round the coil.
  3. To find out if the nail is a magnet, test it with iron filings. What happens if you turn the current off?
  4. Offer your electromagnet some larger bits of iron, such as tintacks or paper clips.
  5. What happens each time you turn the current off?

Teaching Notes

  • Soft iron is a good temporary magnet. A steel nail will retain a lot of its magnetism once the current in the coil is switched off.
  • Iron filings are chips of soft iron which become temporary magnets when in a magnetic field, and so they line up north to south indicating the direction of the magnetic field.
  • How Science Works extension: This experiment can produce a valid relationship between the number of coils and the strength of the electromagnet without any measurements, only counting.
  • After a demonstration of the procedure above, students could be asked to design a version of the experiment which would allow them to investigate two factors affecting the strength of the electromagnet: the number of coils and the current flowing in the wire. The number of paper clips held by the electromagnet could indicate the strength of the electromagnet.
  • This provides an opportunity to discuss the concept of a discrete variable and whether evidence based on discrete variables can lead to a valid conclusion.
  • The scope of variables here is limited, so this would be suitable as a first investigation that students might plan and carry out themselves, with little or no guidance. Encourage students to find appropriate ways in which to present their results to make them clear and easy to understand.
  • If students use the mass of iron filings picked up as a measure of the strength, making measurements can prove problematic. One solution is to have a mass of iron filings on a balance pan, use the electromagnet to remove whatever it can and then record the drop in the balance reading.

This experiment was safety-checked in January 2007

Limit Less Campaign

Support our manifesto for change

The IOP wants to support young people to fulfil their potential by doing physics. Please sign the manifesto today so that we can show our politicians there is widespread support for improving equity and inclusion across the education sector.

Sign today